An auto transformer is an electrical transformer having only one winding. The winding has at least three terminals which is explained in the construction details below.
Some of the advantages of auto-transformer are that,
- they are smaller in size,
- cheap in cost,
- low leakage reactance,
- increased kVA rating,
- low exciting current etc.
An example of application of auto transformer is, using an US electrical equipment rated for 115 V supply (they use 115 V as standard) with higher Indian voltages. Another example could be in starting method of three phase induction motors.
Construction Of Auto Transformer
An auto transformer consists of a single copper wire, which is common in both primary as well as secondary circuit. The copper wire is wound a laminated silicon steel core, with at least three tappings taken out. Secondary and primary circuit share the same neutral point of the winding. The construction is well explained in the diagram. Variable turns ratio at secondary can be obtained by the tappings of the winding (as shown in the figure), or by providing a smooth sliding brush over the winding. Primary terminals are fixed.
Thus, in an auto transformer, you may say, primary and secondary windings are connected magnetically as well as electrically.
Working Of Auto Transformer
As I have described just above, an auto transformer has only one winding which is shared by both primary and secondary circuit, where number of turns shared by secondary are variable. EMF induced in the winding is proportional to the number of turns. Therefore, the secondary voltage can be varied by just varying secondary number of turns.
As winding is common in both circuits, most of the energy is transferred by means of electrical conduction and a small part is transferred through induction.
The considerable disadvantages of an auto transformer are,
- any undesirable condition at primary will affect the equipment at secondary (as windings are not electrically isolated),
- due to low impedance of auto transformer, secondary short circuit currents are very high,
- harmonics generated in the connected equipment will be passed to the supply.
No comments:
Post a Comment